The new bulb and new design

Ive done some studying and in the middle of personal meditations i came up with this concept After all the videos I see I always see some person putting a heat gun up to a twisted monofiliment that maybe pulls couple ounces. Impressive if you have money to pour onto your heating bill just to move a couple ounces. Now ive done some experimentation with tungsten the heat generated by a low amount of voltage is impressive Impressive enough to construct a light bulb that's pure glass In its molten state you would simply torch a few glass bottles or shattered glass in a tray and let the molten pile just flatten out.. Of course you would need an oven to keep all this in its molten state. the next step is to lay your tungsten wire in a wave formation up and down across the molten glass..Being sure the wire buries itself in the glass. Then take a sheet of flashing around the same width as the molten glass tray. This sheet of metal covered in a specialized grease you lay on the molten glass and then you roll the glass the metal sheet and all onto a tight spiral. This bulb is going to be your heat lamp so it needs to have room where the monofiliment muscle goes. So when this glass thing cools its looking like a spiral from the top. the greased up metal sheet is your spacer when removed there is a space where your monofiliment goes and after all this when the bulb is turned on the heat from the tungsten heats the mesh wire and shrinks or condenses but at a cumulative level. suddenly you have the power of 100000 monofiliment wires all at once pulling together. where it would meet a ring cable stop around the bottom of the cage stator 50 holes for 10 speed derailleur cables that would wrap around the housing to be placed up close to the servos you see in the illustration.